EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767314876	241 Count	754 Count	208 Count
1767313075	235 Count	730 Count	203 Count
1767311274	230 Count	711 Count	199 Count
1767309474	225 Count	693 Count	195 Count
1767307673	219 Count	673 Count	190 Count
1767305872	213 Count	652 Count	185 Count
1767304072	203 Count	624 Count	176 Count
1767302277	190 Count	594 Count	164 Count
1767300477	164 Count	543 Count	139 Count
1767298676	157 Count	520 Count	133 Count
1767296875	149 Count	486 Count	126 Count
1767295075	146 Count	472 Count	124 Count
1767293274	142 Count	456 Count	121 Count
1767291473	138 Count	434 Count	118 Count
1767289673	132 Count	408 Count	113 Count
1767287872	126 Count	390 Count	108 Count
1767286071	120 Count	371 Count	103 Count
1767284271	114 Count	351 Count	98 Count
1767282470	106 Count	330 Count	91 Count
1767280677	100 Count	313 Count	86 Count
1767278876	88 Count	290 Count	75 Count
1767277075	82 Count	270 Count	70 Count
1767275275	77 Count	254 Count	66 Count
1767273474	70 Count	234 Count	60 Count
1767271673	65 Count	216 Count	56 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)