EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1784069074	293 Count	936 Count	247 Count
1784067273	288 Count	920 Count	243 Count
1784065472	283 Count	904 Count	239 Count
1784063679	278 Count	889 Count	235 Count
1784061878	273 Count	873 Count	231 Count
1784060077	268 Count	857 Count	227 Count
1784058276	263 Count	836 Count	223 Count
1784056476	258 Count	820 Count	219 Count
1784054675	250 Count	794 Count	212 Count
1784052874	232 Count	742 Count	195 Count
1784051074	227 Count	726 Count	191 Count
1784049273	222 Count	711 Count	187 Count
1784047472	214 Count	689 Count	180 Count
1784045672	200 Count	653 Count	167 Count
1784043871	195 Count	637 Count	163 Count
1784042078	190 Count	621 Count	159 Count
1784040277	183 Count	601 Count	153 Count
1784038477	176 Count	581 Count	147 Count
1784036676	161 Count	540 Count	133 Count
1784034875	156 Count	524 Count	129 Count
1784033075	152 Count	500 Count	126 Count
1784031274	147 Count	482 Count	122 Count
1784029473	142 Count	466 Count	118 Count
1784027673	137 Count	451 Count	114 Count
1784025872	129 Count	428 Count	107 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)