EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785815137	64 Count	271 Count	49 Count
1785813344	60 Count	256 Count	46 Count
1785811544	56 Count	237 Count	43 Count
1785809743	52 Count	216 Count	40 Count
1785807943	48 Count	201 Count	37 Count
1785806142	44 Count	186 Count	34 Count
1785804341	40 Count	169 Count	31 Count
1785802540	37 Count	155 Count	29 Count
1785800740	33 Count	139 Count	26 Count
1785798939	30 Count	127 Count	24 Count
1785797138	23 Count	106 Count	18 Count
1785795338	19 Count	91 Count	15 Count
1785793537	15 Count	67 Count	12 Count
1785791743	11 Count	51 Count	9 Count
1785789943	7 Count	35 Count	6 Count
1785788142	3 Count	14 Count	3 Count
1785786341	304 Count	1012 Count	253 Count
1785784541	300 Count	997 Count	250 Count
1785782740	296 Count	983 Count	247 Count
1785780939	292 Count	968 Count	244 Count
1785779139	288 Count	953 Count	241 Count
1785777338	284 Count	938 Count	238 Count
1785775537	278 Count	918 Count	233 Count
1785773737	274 Count	904 Count	230 Count
1785771936	270 Count	883 Count	227 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)