EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6PTT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PTT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782992162	69 Count	815 Count	62 Count
1782990362	60 Count	704 Count	54 Count
1782988561	51 Count	600 Count	46 Count
1782986760	43 Count	524 Count	40 Count
1782984959	31 Count	348 Count	29 Count
1782983167	19 Count	209 Count	18 Count
1782981366	9 Count	113 Count	9 Count
1782979565	139 Count	1133 Count	128 Count
1782977765	130 Count	993 Count	120 Count
1782975964	121 Count	858 Count	112 Count
1782974163	104 Count	730 Count	97 Count
1782972362	89 Count	588 Count	83 Count
1782970562	71 Count	439 Count	69 Count
1782968761	52 Count	303 Count	51 Count
1782966960	171 Count	1125 Count	165 Count
1782965159	144 Count	945 Count	139 Count
1782963359	117 Count	769 Count	113 Count
1782961566	88 Count	583 Count	85 Count
1782959765	65 Count	439 Count	63 Count
1782957964	45 Count	300 Count	44 Count
1782956164	20 Count	145 Count	20 Count
1782954363	181 Count	1120 Count	174 Count
1782952562	160 Count	970 Count	154 Count
1782950761	140 Count	821 Count	135 Count
1782948960	117 Count	669 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)