EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1760041177	232 Count	527 Count	228 Count
1760039377	204 Count	446 Count	201 Count
1760037576	161 Count	319 Count	159 Count
1760035775	87 Count	197 Count	86 Count
1760033975	40 Count	94 Count	40 Count
1760032174	512 Count	1068 Count	501 Count
1760030374	467 Count	989 Count	457 Count
1760028573	431 Count	918 Count	422 Count
1760026772	396 Count	845 Count	388 Count
1760024972	359 Count	756 Count	352 Count
1760023171	307 Count	657 Count	301 Count
1760021371	270 Count	570 Count	265 Count
1760019570	215 Count	469 Count	211 Count
1760017769	143 Count	334 Count	140 Count
1760015969	98 Count	232 Count	96 Count
1760014168	63 Count	150 Count	62 Count
1760012368	34 Count	81 Count	34 Count
1760010567	460 Count	1006 Count	450 Count
1760008766	424 Count	931 Count	415 Count
1760006966	396 Count	858 Count	388 Count
1760005165	364 Count	779 Count	357 Count
1760003365	329 Count	693 Count	323 Count
1760001564	296 Count	616 Count	291 Count
1759999763	265 Count	541 Count	261 Count
1759997963	217 Count	434 Count	214 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)