EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WM-17 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-17. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789240283	106 Count	792 Count
1789239382	105 Count	780 Count
1789238481	104 Count	766 Count
1789237580	103 Count	754 Count
1789236679	102 Count	741 Count
1789235778	101 Count	737 Count
1789234896	96 Count	733 Count
1789233995	95 Count	730 Count
1789233095	94 Count	723 Count
1789232194	93 Count	719 Count
1789231293	92 Count	715 Count
1789230392	91 Count	712 Count
1789229491	90 Count	696 Count
1789228590	89 Count	691 Count
1789227690	88 Count	688 Count
1789226789	87 Count	684 Count
1789225889	86 Count	671 Count
1789224987	85 Count	654 Count
1789224086	84 Count	650 Count
1789223185	83 Count	646 Count
1789222285	82 Count	642 Count
1789221384	81 Count	638 Count
1789220483	80 Count	634 Count
1789219583	79 Count	630 Count
1789218681	78 Count	622 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)