EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789000093	51 Count	165 Count
1788998293	47 Count	155 Count
1788996492	43 Count	145 Count
1788994691	39 Count	131 Count
1788992890	35 Count	114 Count
1788991090	31 Count	104 Count
1788989289	27 Count	80 Count
1788987488	23 Count	66 Count
1788985696	19 Count	56 Count
1788983895	15 Count	46 Count
1788982094	11 Count	36 Count
1788980293	7 Count	26 Count
1788978493	3 Count	16 Count
1788976692	257 Count	1016 Count
1788974891	253 Count	966 Count
1788973090	250 Count	957 Count
1788971290	246 Count	893 Count
1788969489	242 Count	889 Count
1788967688	238 Count	885 Count
1788965887	234 Count	846 Count
1788964097	230 Count	802 Count
1788962297	226 Count	771 Count
1788960496	222 Count	759 Count
1788958695	218 Count	755 Count
1788956894	214 Count	751 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)