EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IK1TTD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK1TTD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789239091	277 Count	784 Count	254 Count
1789237288	265 Count	754 Count	243 Count
1789235485	252 Count	720 Count	231 Count
1789233682	240 Count	685 Count	220 Count
1789231879	229 Count	653 Count	210 Count
1789230075	218 Count	620 Count	200 Count
1789228268	207 Count	593 Count	190 Count
1789226465	198 Count	561 Count	182 Count
1789224662	186 Count	523 Count	171 Count
1789222889	175 Count	487 Count	161 Count
1789221086	164 Count	455 Count	151 Count
1789219282	152 Count	426 Count	140 Count
1789217479	139 Count	394 Count	128 Count
1789215676	128 Count	366 Count	118 Count
1789213873	116 Count	334 Count	107 Count
1789212070	104 Count	299 Count	96 Count
1789210267	93 Count	266 Count	86 Count
1789208464	84 Count	230 Count	78 Count
1789206661	71 Count	191 Count	66 Count
1789204858	59 Count	158 Count	55 Count
1789203055	48 Count	123 Count	45 Count
1789179692	280 Count	770 Count	257 Count
1789177888	267 Count	749 Count	245 Count
1789176085	255 Count	731 Count	234 Count
1789174282	244 Count	709 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)