EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IK1TTD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK1TTD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1788610854	336 Count	958 Count	308 Count
1788609051	325 Count	929 Count	298 Count
1788607248	315 Count	901 Count	289 Count
1788605445	304 Count	864 Count	279 Count
1788603642	292 Count	833 Count	268 Count
1788601839	280 Count	796 Count	257 Count
1788600036	269 Count	766 Count	247 Count
1788598233	256 Count	738 Count	235 Count
1788596472	244 Count	704 Count	224 Count
1788594669	231 Count	669 Count	212 Count
1788592866	219 Count	635 Count	201 Count
1788591062	209 Count	600 Count	192 Count
1788589259	197 Count	561 Count	181 Count
1788587456	184 Count	523 Count	169 Count
1788585653	173 Count	490 Count	159 Count
1788583847	164 Count	457 Count	151 Count
1788582044	151 Count	426 Count	139 Count
1788580241	139 Count	388 Count	128 Count
1788578438	129 Count	355 Count	119 Count
1788576635	118 Count	319 Count	109 Count
1788574869	105 Count	289 Count	97 Count
1788573066	92 Count	257 Count	85 Count
1788571263	80 Count	227 Count	74 Count
1788569460	70 Count	200 Count	65 Count
1788567656	57 Count	159 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)