EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IZ5IOM-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1792856080	48 Count	201 Count
1792854276	47 Count	191 Count
1792852473	46 Count	190 Count
1792850734	45 Count	183 Count
1792848930	44 Count	181 Count
1792847127	43 Count	173 Count
1792845323	42 Count	173 Count
1792843520	41 Count	166 Count
1792841717	40 Count	163 Count
1792839913	39 Count	158 Count
1792838110	38 Count	152 Count
1792836306	37 Count	151 Count
1792834503	36 Count	145 Count
1792832699	35 Count	139 Count
1792830567	33 Count	136 Count
1792830001	32 Count	136 Count
1792828197	31 Count	130 Count
1792826394	30 Count	127 Count
1792824591	29 Count	122 Count
1792822787	28 Count	113 Count
1792820984	27 Count	112 Count
1792819180	26 Count	112 Count
1792817417	25 Count	112 Count
1792815613	24 Count	112 Count
1792813809	23 Count	112 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)