EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4SAS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SAS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791184238	171 Count	265 Count	153 Count
1791183337	163 Count	248 Count	146 Count
1791182436	153 Count	218 Count	137 Count
1791181536	139 Count	194 Count	124 Count
1791180635	132 Count	182 Count	118 Count
1791179734	123 Count	169 Count	110 Count
1791178833	107 Count	146 Count	95 Count
1791177933	95 Count	128 Count	84 Count
1791177032	72 Count	97 Count	62 Count
1791176131	60 Count	82 Count	51 Count
1791175230	43 Count	58 Count	35 Count
1791174345	31 Count	46 Count	28 Count
1791172544	16 Count	25 Count	15 Count
1791171643	6 Count	11 Count	6 Count
1791170743	535 Count	1006 Count	446 Count
1791169842	528 Count	991 Count	440 Count
1791168941	520 Count	978 Count	433 Count
1791168041	514 Count	963 Count	428 Count
1791167140	507 Count	950 Count	422 Count
1791166239	499 Count	934 Count	415 Count
1791165338	492 Count	922 Count	409 Count
1791164437	484 Count	907 Count	402 Count
1791163537	477 Count	896 Count	396 Count
1791162636	470 Count	881 Count	390 Count
1791161736	460 Count	863 Count	381 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)