EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8SD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786713937	127 Count	233 Count	101 Count
1786713636	120 Count	218 Count	95 Count
1786713336	113 Count	208 Count	89 Count
1786713035	110 Count	201 Count	87 Count
1786712735	102 Count	187 Count	80 Count
1786712434	94 Count	175 Count	73 Count
1786712134	91 Count	169 Count	71 Count
1786711833	87 Count	159 Count	68 Count
1786711536	83 Count	151 Count	65 Count
1786711232	74 Count	133 Count	57 Count
1786710931	70 Count	125 Count	54 Count
1786710631	64 Count	117 Count	49 Count
1786710330	61 Count	110 Count	47 Count
1786710030	52 Count	95 Count	39 Count
1786709729	45 Count	85 Count	33 Count
1786709429	43 Count	77 Count	32 Count
1786709128	36 Count	65 Count	26 Count
1786708827	31 Count	56 Count	22 Count
1786708527	26 Count	45 Count	18 Count
1786708226	22 Count	36 Count	15 Count
1786707926	15 Count	25 Count	9 Count
1786707625	12 Count	21 Count	7 Count
1786707067	593 Count	1003 Count	509 Count
1786706766	587 Count	987 Count	504 Count
1786706466	577 Count	970 Count	495 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)