EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ7AYZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7AYZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785862357	38 Count	390 Count	26 Count
1785860556	35 Count	388 Count	24 Count
1785858756	32 Count	386 Count	22 Count
1785856955	29 Count	384 Count	20 Count
1785855162	27 Count	383 Count	19 Count
1785853362	24 Count	381 Count	17 Count
1785851561	21 Count	379 Count	15 Count
1785849760	17 Count	356 Count	12 Count
1785847959	14 Count	310 Count	10 Count
1785846159	11 Count	248 Count	8 Count
1785844358	8 Count	185 Count	6 Count
1785840757	2 Count	64 Count	2 Count
1785838956	155 Count	1028 Count	148 Count
1785837156	152 Count	959 Count	146 Count
1785833562	147 Count	853 Count	143 Count
1785831761	137 Count	764 Count	134 Count
1785829961	121 Count	668 Count	119 Count
1785828160	105 Count	548 Count	104 Count
1785826359	65 Count	296 Count	65 Count
1785824559	335 Count	1313 Count	327 Count
1785822758	245 Count	944 Count	238 Count
1785820957	181 Count	642 Count	175 Count
1785819156	133 Count	439 Count	128 Count
1785815555	62 Count	193 Count	59 Count
1785813754	35 Count	107 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)