EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

DJ1FC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DJ1FC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1791100975	20 Count	190 Count
1791097367	18 Count	161 Count
1791093759	16 Count	147 Count
1791090150	14 Count	124 Count
1791086542	12 Count	98 Count
1791082934	10 Count	83 Count
1791079326	8 Count	64 Count
1791075718	6 Count	41 Count
1791072109	4 Count	28 Count
1791068501	2 Count	14 Count
1791064893	0 Count	0 Count
1791061431	57 Count	981 Count
1791057822	55 Count	976 Count
1791054214	53 Count	965 Count
1791050606	51 Count	956 Count
1791046998	49 Count	941 Count
1791043390	47 Count	878 Count
1791039782	45 Count	809 Count
1791036173	43 Count	744 Count
1791032565	41 Count	665 Count
1791028957	39 Count	559 Count
1791025349	37 Count	504 Count
1791021741	35 Count	487 Count
1791018133	33 Count	445 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)