EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

2E0LXY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2E0LXY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1783125044	108 Count	191 Count	28 Count
1783123241	82 Count	143 Count	21 Count
1783122761	75 Count	130 Count	19 Count
1783120958	49 Count	91 Count	11 Count
1783119154	29 Count	47 Count	6 Count
1783117351	1014 Count	486 Count	57 Count
1783115547	995 Count	445 Count	51 Count
1783113744	983 Count	392 Count	45 Count
1783112467	978 Count	351 Count	41 Count
1783110663	955 Count	306 Count	37 Count
1783108860	946 Count	258 Count	32 Count
1783107055	923 Count	175 Count	21 Count
1783105252	909 Count	98 Count	16 Count
1783103448	896 Count	43 Count	6 Count
1783101645	881 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)