EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F6KNH-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6KNH-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783146977	762 Count	363 Count	260 Count
1783145173	758 Count	360 Count	257 Count
1783141566	755 Count	359 Count	256 Count
1783139762	753 Count	358 Count	255 Count
1783138000	747 Count	357 Count	254 Count
1783136196	744 Count	355 Count	252 Count
1783134392	743 Count	355 Count	252 Count
1783132588	740 Count	353 Count	250 Count
1783130785	737 Count	351 Count	248 Count
1783127177	732 Count	348 Count	245 Count
1783125374	729 Count	346 Count	243 Count
1783123570	727 Count	345 Count	242 Count
1783121766	726 Count	345 Count	242 Count
1783119962	725 Count	345 Count	242 Count
1783116396	719 Count	345 Count	242 Count
1783114593	718 Count	345 Count	242 Count
1783112789	715 Count	343 Count	240 Count
1783110985	713 Count	342 Count	239 Count
1783109181	711 Count	341 Count	238 Count
1783107378	710 Count	341 Count	238 Count
1783105574	709 Count	341 Count	238 Count
1783103770	708 Count	341 Count	238 Count
1783101966	707 Count	341 Count	238 Count
1783100163	706 Count	341 Count	238 Count
1783096555	704 Count	341 Count	238 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)