EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9BOT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9BOT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794221984	22 Count	379 Count	11 Count
1794221384	19 Count	358 Count	9 Count
1794220783	18 Count	321 Count	9 Count
1794220182	16 Count	285 Count	8 Count
1794219581	13 Count	251 Count	6 Count
1794218981	12 Count	215 Count	6 Count
1794218409	11 Count	176 Count	6 Count
1794217808	8 Count	140 Count	4 Count
1794217207	7 Count	110 Count	4 Count
1794216606	5 Count	81 Count	3 Count
1794216006	2 Count	48 Count	1 Count
1794215405	1 Count	21 Count	1 Count
1794214804	63 Count	1025 Count	33 Count
1794214203	60 Count	997 Count	31 Count
1794213603	59 Count	972 Count	31 Count
1794213002	57 Count	951 Count	30 Count
1794212401	50 Count	904 Count	24 Count
1794211800	49 Count	876 Count	24 Count
1794211200	47 Count	850 Count	23 Count
1794210599	44 Count	811 Count	21 Count
1794209997	43 Count	780 Count	21 Count
1794209396	41 Count	754 Count	20 Count
1794208796	38 Count	725 Count	18 Count
1794208195	37 Count	695 Count	18 Count
1794207594	35 Count	659 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)