EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

KC7HES-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC7HES-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789189646	55 Count	806 Count	38 Count
1789187845	49 Count	747 Count	35 Count
1789186045	45 Count	649 Count	32 Count
1789184245	35 Count	552 Count	23 Count
1789160849	58 Count	607 Count	43 Count
1789159049	40 Count	497 Count	28 Count
1789157248	36 Count	435 Count	25 Count
1789155448	30 Count	361 Count	22 Count
1789153647	19 Count	281 Count	12 Count
1789151847	13 Count	211 Count	9 Count
1789150046	9 Count	150 Count	6 Count
1789148246	3 Count	67 Count	3 Count
1789146445	65 Count	1029 Count	50 Count
1789144645	59 Count	959 Count	47 Count
1789142844	54 Count	891 Count	43 Count
1789141044	50 Count	818 Count	40 Count
1789139246	46 Count	739 Count	37 Count
1789137446	40 Count	650 Count	32 Count
1789135645	30 Count	471 Count	23 Count
1789133845	14 Count	270 Count	10 Count
1789132045	10 Count	169 Count	7 Count
1789130244	3 Count	83 Count	3 Count
1789128444	74 Count	1007 Count	50 Count
1789126644	67 Count	920 Count	46 Count
1789124843	61 Count	826 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)