EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

XE2OK-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2OK-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1793192553	403 Count	787 Count	317 Count
1793191647	399 Count	777 Count	314 Count
1793190743	393 Count	767 Count	309 Count
1793189840	391 Count	758 Count	308 Count
1793188937	386 Count	748 Count	304 Count
1793188034	383 Count	740 Count	302 Count
1793187131	377 Count	731 Count	297 Count
1793186228	374 Count	722 Count	295 Count
1793185325	369 Count	713 Count	291 Count
1793184422	365 Count	704 Count	288 Count
1793183519	359 Count	694 Count	283 Count
1793182616	355 Count	684 Count	280 Count
1793181713	349 Count	671 Count	275 Count
1793180810	345 Count	664 Count	272 Count
1793179907	339 Count	653 Count	267 Count
1793179004	336 Count	642 Count	265 Count
1793178101	330 Count	630 Count	260 Count
1793176369	317 Count	614 Count	254 Count
1793175466	312 Count	605 Count	250 Count
1793174563	308 Count	596 Count	247 Count
1793173660	304 Count	588 Count	244 Count
1793172753	299 Count	578 Count	240 Count
1793171854	295 Count	567 Count	237 Count
1793170950	291 Count	555 Count	234 Count
1793170044	287 Count	545 Count	231 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)