EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

DG1MJG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1MJG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789413715	843 Count	717 Count
1789413112	842 Count	717 Count
1789412508	841 Count	717 Count
1789411904	840 Count	717 Count
1789411301	839 Count	717 Count
1789410698	838 Count	714 Count
1789410095	837 Count	714 Count
1789409492	836 Count	711 Count
1789408888	835 Count	709 Count
1789408284	834 Count	708 Count
1789407681	833 Count	707 Count
1789407078	832 Count	702 Count
1789406475	831 Count	699 Count
1789405871	830 Count	699 Count
1789405268	829 Count	697 Count
1789404664	828 Count	696 Count
1789404061	827 Count	696 Count
1789403458	826 Count	692 Count
1789402855	825 Count	691 Count
1789402252	824 Count	689 Count
1789401648	823 Count	687 Count
1789401044	822 Count	686 Count
1789400441	821 Count	684 Count
1789399838	820 Count	682 Count
1789399235	819 Count	680 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)