EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OE4EXE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE4EXE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787547189	81 Count	953 Count
1787546586	80 Count	944 Count
1787545982	79 Count	928 Count
1787545378	78 Count	911 Count
1787544775	77 Count	894 Count
1787544171	76 Count	880 Count
1787543567	75 Count	868 Count
1787542964	74 Count	850 Count
1787542360	73 Count	837 Count
1787541756	72 Count	816 Count
1787541153	71 Count	802 Count
1787540549	70 Count	793 Count
1787539945	69 Count	784 Count
1787539342	68 Count	763 Count
1787538738	67 Count	750 Count
1787538134	66 Count	736 Count
1787537531	65 Count	725 Count
1787536927	64 Count	712 Count
1787536323	63 Count	704 Count
1787535853	62 Count	689 Count
1787535249	61 Count	677 Count
1787534645	60 Count	663 Count
1787534042	59 Count	647 Count
1787533438	58 Count	630 Count
1787532834	57 Count	617 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)