EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M6MTR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M6MTR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1781181962	622 Count	584 Count	294 Count
1781181361	620 Count	582 Count	293 Count
1781180760	618 Count	580 Count	292 Count
1781180160	616 Count	578 Count	291 Count
1781179559	614 Count	576 Count	290 Count
1781178959	612 Count	574 Count	289 Count
1781178358	610 Count	572 Count	288 Count
1781177757	608 Count	570 Count	287 Count
1781177156	606 Count	568 Count	286 Count
1781176556	604 Count	566 Count	285 Count
1781175955	602 Count	564 Count	284 Count
1781175354	600 Count	562 Count	283 Count
1781174754	598 Count	560 Count	282 Count
1781174153	596 Count	558 Count	281 Count
1781173552	594 Count	556 Count	280 Count
1781172952	592 Count	554 Count	279 Count
1781172351	590 Count	552 Count	278 Count
1781132666	583 Count	550 Count	277 Count
1781132065	581 Count	548 Count	276 Count
1781131465	579 Count	546 Count	275 Count
1781130864	577 Count	544 Count	274 Count
1781130263	575 Count	542 Count	273 Count
1781129663	573 Count	540 Count	272 Count
1781129062	571 Count	538 Count	271 Count
1781128461	569 Count	536 Count	270 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)