EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M9PHD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9PHD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781178888	815 Count	584 Count	304 Count
1781178287	813 Count	582 Count	303 Count
1781177687	811 Count	580 Count	302 Count
1781177086	809 Count	578 Count	301 Count
1781176485	807 Count	576 Count	300 Count
1781175884	805 Count	574 Count	299 Count
1781175284	803 Count	572 Count	298 Count
1781174683	801 Count	570 Count	297 Count
1781174082	799 Count	568 Count	296 Count
1781173482	797 Count	566 Count	295 Count
1781172881	795 Count	564 Count	294 Count
1781172280	793 Count	562 Count	293 Count
1781171680	789 Count	559 Count	290 Count
1781171628	788 Count	559 Count	290 Count
1781171610	787 Count	559 Count	290 Count
1781171289	786 Count	559 Count	290 Count
1781170688	785 Count	559 Count	290 Count
1781170087	784 Count	559 Count	290 Count
1781169487	783 Count	559 Count	290 Count
1781168886	782 Count	559 Count	290 Count
1781168285	781 Count	559 Count	290 Count
1781167684	780 Count	559 Count	290 Count
1781167084	779 Count	559 Count	290 Count
1781166483	778 Count	559 Count	290 Count
1781165882	777 Count	559 Count	290 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)