EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762359485	267 Count	252 Count	245 Count
1762357682	249 Count	232 Count	228 Count
1762355878	229 Count	212 Count	209 Count
1762354075	213 Count	199 Count	196 Count
1762352272	196 Count	183 Count	180 Count
1762350469	171 Count	158 Count	156 Count
1762348665	148 Count	136 Count	134 Count
1762346862	141 Count	132 Count	130 Count
1762345058	138 Count	130 Count	128 Count
1762343255	124 Count	117 Count	115 Count
1762341452	117 Count	111 Count	109 Count
1762339647	100 Count	97 Count	95 Count
1762337842	82 Count	80 Count	78 Count
1762336039	60 Count	58 Count	57 Count
1762334236	40 Count	39 Count	38 Count
1762332433	20 Count	20 Count	20 Count
1762330629	1007 Count	954 Count	941 Count
1762328826	984 Count	929 Count	919 Count
1762327023	952 Count	897 Count	888 Count
1762325220	943 Count	891 Count	883 Count
1762323417	937 Count	886 Count	878 Count
1762321614	924 Count	874 Count	866 Count
1762319811	895 Count	845 Count	838 Count
1762318008	861 Count	814 Count	807 Count
1762316205	826 Count	780 Count	773 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)