EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787221106	802 Count	568 Count	187 Count
1787219303	801 Count	568 Count	187 Count
1787217500	799 Count	567 Count	186 Count
1787215697	798 Count	567 Count	186 Count
1787212091	794 Count	565 Count	184 Count
1787210288	792 Count	564 Count	183 Count
1787208485	790 Count	563 Count	182 Count
1787206682	788 Count	562 Count	181 Count
1787204879	785 Count	560 Count	179 Count
1787203076	782 Count	550 Count	177 Count
1787199469	776 Count	546 Count	173 Count
1787195863	764 Count	536 Count	163 Count
1787194060	763 Count	536 Count	163 Count
1787192257	762 Count	536 Count	163 Count
1787190454	761 Count	536 Count	163 Count
1787188651	760 Count	536 Count	163 Count
1787181439	756 Count	536 Count	163 Count
1787177833	754 Count	536 Count	163 Count
1787176030	753 Count	536 Count	163 Count
1787174227	752 Count	536 Count	163 Count
1787167015	748 Count	536 Count	163 Count
1787165212	745 Count	534 Count	161 Count
1787163409	744 Count	534 Count	161 Count
1787161605	743 Count	534 Count	161 Count
1787159802	742 Count	534 Count	161 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)