EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782993702	23 Count	428 Count	13 Count
1782991901	20 Count	385 Count	11 Count
1782990111	18 Count	343 Count	10 Count
1782988310	16 Count	298 Count	9 Count
1782986509	12 Count	261 Count	7 Count
1782984708	10 Count	222 Count	6 Count
1782982907	8 Count	176 Count	5 Count
1782981106	6 Count	136 Count	4 Count
1782979305	3 Count	91 Count	2 Count
1782977505	1 Count	51 Count	1 Count
1782975704	322 Count	1034 Count	181 Count
1782973903	320 Count	965 Count	180 Count
1782972102	318 Count	956 Count	179 Count
1782968510	313 Count	940 Count	176 Count
1782966709	311 Count	933 Count	175 Count
1782964908	309 Count	925 Count	174 Count
1782963107	307 Count	918 Count	173 Count
1782961306	304 Count	910 Count	171 Count
1782959506	302 Count	899 Count	170 Count
1782957706	300 Count	890 Count	169 Count
1782955904	298 Count	882 Count	168 Count
1782954103	296 Count	874 Count	167 Count
1782952302	293 Count	861 Count	165 Count
1782950501	291 Count	851 Count	164 Count
1782948700	289 Count	839 Count	163 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)