EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1789226296	266 Count	133 Count	106 Count
1789224615	206 Count	104 Count	82 Count
1789222935	158 Count	79 Count	62 Count
1789221253	96 Count	48 Count	36 Count
1789219572	46 Count	23 Count	17 Count
1789217892	1023 Count	518 Count	338 Count
1789216211	972 Count	490 Count	320 Count
1789214530	937 Count	471 Count	308 Count
1789212849	906 Count	458 Count	300 Count
1789211168	855 Count	431 Count	281 Count
1789209488	811 Count	407 Count	263 Count
1789208055	779 Count	394 Count	253 Count
1789206374	730 Count	372 Count	235 Count
1789204693	702 Count	359 Count	226 Count
1789203012	670 Count	343 Count	215 Count
1789201331	629 Count	318 Count	201 Count
1789199651	598 Count	302 Count	191 Count
1789197970	555 Count	282 Count	176 Count
1789196289	519 Count	264 Count	164 Count
1789194608	486 Count	247 Count	153 Count
1789192928	463 Count	235 Count	147 Count
1789191247	444 Count	226 Count	143 Count
1789189566	395 Count	201 Count	124 Count
1789187885	357 Count	182 Count	111 Count
1789186454	323 Count	166 Count	100 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)