EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1785821503	134 Count	73 Count	56 Count
1785819822	75 Count	42 Count	31 Count
1785818143	41 Count	21 Count	16 Count
1785816711	1024 Count	574 Count	433 Count
1785815030	973 Count	545 Count	411 Count
1785813349	911 Count	512 Count	384 Count
1785811668	848 Count	477 Count	356 Count
1785809987	788 Count	444 Count	330 Count
1785808306	725 Count	403 Count	302 Count
1785806626	679 Count	378 Count	283 Count
1785804945	641 Count	358 Count	268 Count
1785803264	622 Count	347 Count	263 Count
1785801583	600 Count	332 Count	256 Count
1785799902	553 Count	301 Count	237 Count
1785798222	508 Count	276 Count	218 Count
1785795111	431 Count	232 Count	186 Count
1785793430	389 Count	208 Count	168 Count
1785791749	353 Count	189 Count	154 Count
1785790068	329 Count	175 Count	146 Count
1785788388	310 Count	164 Count	141 Count
1785786707	277 Count	146 Count	128 Count
1785785026	210 Count	112 Count	98 Count
1785783345	78 Count	42 Count	36 Count
1785781664	1035 Count	588 Count	405 Count
1785779983	954 Count	544 Count	367 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)