EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773740717	529 Count	587 Count	285 Count
1773737116	527 Count	587 Count	285 Count
1773735315	526 Count	587 Count	285 Count
1773731714	524 Count	587 Count	285 Count
1773729921	511 Count	579 Count	277 Count
1773726320	509 Count	579 Count	277 Count
1773724519	508 Count	579 Count	277 Count
1773722718	507 Count	578 Count	277 Count
1773720918	506 Count	578 Count	277 Count
1773719117	505 Count	577 Count	277 Count
1773717316	504 Count	576 Count	277 Count
1773715515	502 Count	573 Count	276 Count
1773713714	500 Count	571 Count	275 Count
1773711913	498 Count	568 Count	274 Count
1773710113	497 Count	567 Count	274 Count
1773708320	492 Count	567 Count	274 Count
1773706518	491 Count	567 Count	274 Count
1773704718	489 Count	566 Count	273 Count
1773702918	486 Count	563 Count	271 Count
1773701116	483 Count	561 Count	269 Count
1773699316	480 Count	557 Count	267 Count
1773697515	477 Count	555 Count	265 Count
1773695714	474 Count	553 Count	263 Count
1773693914	471 Count	551 Count	261 Count
1773692113	468 Count	549 Count	259 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)