EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773776717	574 Count	605 Count	302 Count
1773774917	573 Count	605 Count	302 Count
1773773123	566 Count	603 Count	300 Count
1773771322	565 Count	603 Count	300 Count
1773769522	564 Count	603 Count	300 Count
1773767721	563 Count	603 Count	300 Count
1773765920	562 Count	603 Count	300 Count
1773764119	561 Count	603 Count	300 Count
1773760518	559 Count	603 Count	300 Count
1773758717	549 Count	594 Count	291 Count
1773756916	544 Count	589 Count	287 Count
1773755116	543 Count	589 Count	287 Count
1773753315	542 Count	589 Count	287 Count
1773751522	537 Count	589 Count	287 Count
1773749721	536 Count	589 Count	287 Count
1773747920	535 Count	589 Count	287 Count
1773746119	534 Count	589 Count	287 Count
1773744319	531 Count	587 Count	285 Count
1773742518	530 Count	587 Count	285 Count
1773740717	529 Count	587 Count	285 Count
1773737116	527 Count	587 Count	285 Count
1773735315	526 Count	587 Count	285 Count
1773731714	524 Count	587 Count	285 Count
1773729921	511 Count	579 Count	277 Count
1773726320	509 Count	579 Count	277 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)