EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IU5RCJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU5RCJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1779055410	66 Count	7 Count	1 Count
1779054504	52 Count	6 Count	1 Count
1779053600	40 Count	6 Count	1 Count
1779052696	25 Count	6 Count	1 Count
1779051793	13 Count	6 Count	1 Count
1779050889	1001 Count	636 Count	163 Count
1779049986	986 Count	625 Count	161 Count
1779049082	970 Count	609 Count	160 Count
1779048178	956 Count	604 Count	158 Count
1779047365	943 Count	599 Count	158 Count
1779046460	929 Count	589 Count	157 Count
1779045556	912 Count	584 Count	155 Count
1779044653	896 Count	570 Count	153 Count
1779043749	881 Count	565 Count	152 Count
1779042846	865 Count	560 Count	150 Count
1779041942	849 Count	555 Count	148 Count
1779041036	834 Count	549 Count	145 Count
1779040132	818 Count	543 Count	143 Count
1779039228	799 Count	534 Count	138 Count
1779038324	782 Count	527 Count	136 Count
1779037421	768 Count	518 Count	134 Count
1779036517	750 Count	512 Count	131 Count
1779035614	731 Count	502 Count	127 Count
1779034710	713 Count	495 Count	125 Count
1779033806	700 Count	488 Count	123 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)