EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789234624	121 Count	483 Count	99 Count
1789233720	118 Count	471 Count	97 Count
1789232816	113 Count	460 Count	94 Count
1789231913	110 Count	450 Count	92 Count
1789231009	107 Count	438 Count	90 Count
1789230106	105 Count	430 Count	89 Count
1789229202	102 Count	419 Count	87 Count
1789228299	99 Count	410 Count	85 Count
1789227395	95 Count	390 Count	82 Count
1789226492	88 Count	369 Count	76 Count
1789225588	84 Count	349 Count	73 Count
1789224685	77 Count	326 Count	67 Count
1789223780	73 Count	303 Count	64 Count
1789222877	69 Count	233 Count	61 Count
1789221973	62 Count	197 Count	55 Count
1789221070	58 Count	178 Count	52 Count
1789220166	51 Count	157 Count	46 Count
1789219346	47 Count	140 Count	43 Count
1789218443	42 Count	120 Count	39 Count
1789217539	36 Count	93 Count	34 Count
1789216639	22 Count	59 Count	21 Count
1789215732	7 Count	25 Count	7 Count
1789214829	470 Count	1016 Count	343 Count
1789213925	459 Count	982 Count	333 Count
1789213022	437 Count	944 Count	312 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)