EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1792865307	658 Count	701 Count	472 Count
1792864404	657 Count	700 Count	472 Count
1792863500	656 Count	700 Count	472 Count
1792862595	642 Count	687 Count	459 Count
1792861692	626 Count	670 Count	444 Count
1792860788	625 Count	669 Count	444 Count
1792859885	624 Count	669 Count	444 Count
1792858981	623 Count	668 Count	444 Count
1792858078	621 Count	667 Count	443 Count
1792857174	620 Count	667 Count	443 Count
1792856271	618 Count	665 Count	442 Count
1792855367	616 Count	663 Count	441 Count
1792854464	614 Count	661 Count	440 Count
1792853560	613 Count	660 Count	440 Count
1792852657	611 Count	658 Count	439 Count
1792851753	609 Count	656 Count	438 Count
1792850850	608 Count	655 Count	438 Count
1792849946	606 Count	653 Count	437 Count
1792849042	604 Count	651 Count	436 Count
1792848226	603 Count	650 Count	436 Count
1792847322	601 Count	648 Count	435 Count
1792846417	599 Count	646 Count	434 Count
1792845513	597 Count	644 Count	433 Count
1792844610	595 Count	642 Count	432 Count
1792843710	593 Count	640 Count	431 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)