EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M9NSZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9NSZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790495459	117 Count	818 Count
1790493656	116 Count	797 Count
1790491889	115 Count	778 Count
1790490086	114 Count	761 Count
1790488282	113 Count	741 Count
1790486479	112 Count	734 Count
1790484676	111 Count	726 Count
1790482873	110 Count	712 Count
1790481070	109 Count	701 Count
1790479267	108 Count	690 Count
1790477464	107 Count	680 Count
1790475661	106 Count	671 Count
1790473857	105 Count	663 Count
1790472054	104 Count	654 Count
1790470287	103 Count	647 Count
1790468484	102 Count	639 Count
1790466680	101 Count	633 Count
1790464877	100 Count	624 Count
1790463074	99 Count	618 Count
1790461271	98 Count	610 Count
1790459468	97 Count	604 Count
1790457665	96 Count	593 Count
1790455862	95 Count	584 Count
1790454059	94 Count	577 Count
1790452256	93 Count	574 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)