EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

DL1KDA-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777114769	56 Count	135 Count	51 Count
1777112965	48 Count	112 Count	44 Count
1777111161	37 Count	87 Count	34 Count
1777109357	31 Count	70 Count	29 Count
1777107553	19 Count	41 Count	18 Count
1777105749	11 Count	22 Count	11 Count
1777103945	424 Count	1006 Count	393 Count
1777102141	417 Count	987 Count	387 Count
1777100337	400 Count	946 Count	371 Count
1777098533	377 Count	860 Count	349 Count
1777096729	359 Count	770 Count	332 Count
1777094925	346 Count	745 Count	320 Count
1777093121	327 Count	694 Count	302 Count
1777091316	300 Count	643 Count	276 Count
1777089512	288 Count	619 Count	265 Count
1777087709	274 Count	572 Count	252 Count
1777085905	256 Count	517 Count	235 Count
1777084100	246 Count	469 Count	226 Count
1777082296	227 Count	426 Count	208 Count
1777080496	216 Count	404 Count	198 Count
1777078688	204 Count	382 Count	187 Count
1777076884	195 Count	363 Count	179 Count
1777075080	185 Count	343 Count	170 Count
1777073276	180 Count	328 Count	166 Count
1777071472	168 Count	306 Count	155 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)