EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

DL1KDA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1781208445	665 Count	995 Count	471 Count
1781206641	658 Count	979 Count	465 Count
1781204837	649 Count	961 Count	457 Count
1781203032	641 Count	945 Count	450 Count
1781201228	638 Count	939 Count	448 Count
1781199424	636 Count	933 Count	447 Count
1781197619	633 Count	928 Count	445 Count
1781195815	631 Count	925 Count	444 Count
1781194011	629 Count	923 Count	443 Count
1781192207	626 Count	920 Count	441 Count
1781190402	625 Count	920 Count	441 Count
1781188598	624 Count	920 Count	441 Count
1781186842	622 Count	919 Count	440 Count
1781185038	620 Count	918 Count	439 Count
1781183234	618 Count	914 Count	438 Count
1781181429	617 Count	914 Count	438 Count
1781179625	616 Count	914 Count	438 Count
1781177821	610 Count	908 Count	433 Count
1781176017	586 Count	885 Count	410 Count
1781174213	576 Count	876 Count	401 Count
1781172408	575 Count	876 Count	401 Count
1781170604	574 Count	875 Count	401 Count
1781168800	568 Count	869 Count	396 Count
1781166996	567 Count	869 Count	396 Count
1781165245	565 Count	868 Count	396 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)