EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9SXN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SXN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777152080	533 Count	145 Count	144 Count
1777150279	532 Count	145 Count	144 Count
1777148478	530 Count	145 Count	144 Count
1777146677	529 Count	145 Count	144 Count
1777144877	527 Count	145 Count	144 Count
1777143946	526 Count	145 Count	144 Count
1777142887	525 Count	145 Count	144 Count
1777141086	513 Count	135 Count	134 Count
1777139286	512 Count	135 Count	134 Count
1777137485	505 Count	130 Count	129 Count
1777135684	500 Count	126 Count	125 Count
1777132091	497 Count	126 Count	125 Count
1777130290	495 Count	126 Count	125 Count
1777128489	475 Count	107 Count	106 Count
1777126688	469 Count	104 Count	103 Count
1777124888	467 Count	103 Count	102 Count
1777123087	465 Count	103 Count	102 Count
1777121286	464 Count	103 Count	102 Count
1777119486	462 Count	103 Count	102 Count
1777117685	458 Count	100 Count	99 Count
1777115884	455 Count	99 Count	98 Count
1777114083	454 Count	99 Count	98 Count
1777112283	452 Count	99 Count	98 Count
1777110491	451 Count	99 Count	98 Count
1777108690	444 Count	94 Count	93 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)