EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

ON4CDR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4CDR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784781499	204 Count	567 Count
1784780596	190 Count	508 Count
1784779691	171 Count	462 Count
1784778788	156 Count	435 Count
1784777885	137 Count	393 Count
1784776981	122 Count	352 Count
1784776078	102 Count	321 Count
1784775175	87 Count	241 Count
1784774272	68 Count	174 Count
1784773367	53 Count	129 Count
1784772464	34 Count	83 Count
1784771561	18 Count	41 Count
1784770657	416 Count	1033 Count
1784769753	401 Count	988 Count
1784768850	382 Count	948 Count
1784767947	368 Count	911 Count
1784767045	347 Count	875 Count
1784766142	333 Count	834 Count
1784765239	314 Count	796 Count
1784764335	299 Count	750 Count
1784763432	280 Count	708 Count
1784762529	264 Count	668 Count
1784761703	247 Count	626 Count
1784760800	233 Count	589 Count
1784759897	214 Count	549 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)