EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789255132	91 Count	438 Count	74 Count
1789253329	86 Count	411 Count	70 Count
1789251526	81 Count	385 Count	66 Count
1789249723	76 Count	354 Count	62 Count
1789247920	69 Count	323 Count	56 Count
1789246155	66 Count	296 Count	54 Count
1789244350	60 Count	272 Count	49 Count
1789242547	55 Count	255 Count	45 Count
1789240744	50 Count	226 Count	41 Count
1789238940	45 Count	203 Count	37 Count
1789237137	39 Count	179 Count	32 Count
1789235334	34 Count	159 Count	28 Count
1789233531	29 Count	132 Count	24 Count
1789231728	26 Count	90 Count	22 Count
1789229925	21 Count	71 Count	18 Count
1789228122	15 Count	56 Count	13 Count
1789226319	10 Count	37 Count	9 Count
1789224553	4 Count	20 Count	4 Count
1789222750	134 Count	1011 Count	109 Count
1789220947	129 Count	992 Count	105 Count
1789219143	124 Count	972 Count	101 Count
1789217340	120 Count	956 Count	98 Count
1789215537	118 Count	942 Count	97 Count
1789213734	112 Count	926 Count	92 Count
1789211931	107 Count	908 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)