EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787608193	82 Count	210 Count	73 Count
1787606390	74 Count	189 Count	66 Count
1787604623	67 Count	174 Count	60 Count
1787602820	59 Count	157 Count	53 Count
1787601017	51 Count	136 Count	46 Count
1787599214	42 Count	112 Count	38 Count
1787597411	26 Count	88 Count	24 Count
1787595608	17 Count	42 Count	16 Count
1787593804	9 Count	21 Count	9 Count
1787592001	401 Count	1002 Count	347 Count
1787590198	391 Count	981 Count	338 Count
1787588395	380 Count	959 Count	328 Count
1787586592	370 Count	937 Count	319 Count
1787584789	362 Count	916 Count	312 Count
1787583023	354 Count	897 Count	305 Count
1787581219	348 Count	879 Count	300 Count
1787579416	342 Count	860 Count	295 Count
1787577613	336 Count	844 Count	290 Count
1787575810	330 Count	828 Count	285 Count
1787574007	324 Count	814 Count	280 Count
1787572204	318 Count	798 Count	275 Count
1787570400	313 Count	782 Count	271 Count
1787568597	299 Count	754 Count	260 Count
1787566794	293 Count	739 Count	255 Count
1787564991	287 Count	722 Count	250 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)