EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

K9TWL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K9TWL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783454588	151 Count	118 Count	118 Count
1783452784	148 Count	116 Count	116 Count
1783450981	144 Count	113 Count	113 Count
1783449178	137 Count	107 Count	107 Count
1783447375	134 Count	105 Count	105 Count
1783445571	131 Count	103 Count	103 Count
1783443768	126 Count	99 Count	99 Count
1783441965	123 Count	97 Count	97 Count
1783440162	120 Count	95 Count	95 Count
1783438359	116 Count	92 Count	92 Count
1783414994	60 Count	49 Count	49 Count
1783413190	57 Count	47 Count	47 Count
1783411387	53 Count	44 Count	44 Count
1783409583	50 Count	42 Count	42 Count
1783407780	47 Count	40 Count	40 Count
1783405975	41 Count	35 Count	35 Count
1783404171	31 Count	26 Count	26 Count
1783402368	27 Count	23 Count	23 Count
1783400565	23 Count	20 Count	20 Count
1783398762	15 Count	13 Count	13 Count
1783396959	8 Count	7 Count	7 Count
1783395156	0 Count	0 Count	0 Count
1783393392	991 Count	309 Count	309 Count
1783391589	984 Count	303 Count	303 Count
1783389786	981 Count	301 Count	301 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)