EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9OE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9OE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790848710	363 Count	387 Count	363 Count
1790846910	358 Count	382 Count	358 Count
1790845110	343 Count	367 Count	343 Count
1790843310	317 Count	341 Count	317 Count
1790841510	283 Count	302 Count	283 Count
1790839710	255 Count	273 Count	255 Count
1790837910	224 Count	240 Count	224 Count
1790836110	205 Count	221 Count	205 Count
1790834310	194 Count	209 Count	194 Count
1790832510	178 Count	192 Count	178 Count
1790830710	167 Count	180 Count	167 Count
1790828910	152 Count	162 Count	152 Count
1790827110	133 Count	143 Count	133 Count
1790825310	115 Count	124 Count	115 Count
1790823509	101 Count	109 Count	101 Count
1790821709	73 Count	80 Count	73 Count
1790800108	342 Count	840 Count	342 Count
1790800069	342 Count	840 Count	342 Count
1790798809	342 Count	840 Count	342 Count
1790797009	320 Count	818 Count	320 Count
1790795209	314 Count	811 Count	314 Count
1790793409	312 Count	809 Count	312 Count
1790791609	305 Count	802 Count	305 Count
1790790244	303 Count	798 Count	303 Count
1790788436	300 Count	795 Count	300 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)