EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780171644	134 Count	495 Count	91 Count
1780168942	131 Count	477 Count	91 Count
1780168042	130 Count	456 Count	91 Count
1780166240	123 Count	437 Count	86 Count
1780165340	122 Count	433 Count	86 Count
1780164439	121 Count	429 Count	86 Count
1780163539	114 Count	414 Count	80 Count
1780162638	111 Count	406 Count	78 Count
1780161737	109 Count	396 Count	77 Count
1780160837	106 Count	360 Count	75 Count
1780159936	99 Count	340 Count	69 Count
1780159035	96 Count	329 Count	67 Count
1780158135	94 Count	320 Count	66 Count
1780157234	91 Count	309 Count	64 Count
1780156334	88 Count	276 Count	62 Count
1780155433	86 Count	271 Count	61 Count
1780154532	83 Count	257 Count	60 Count
1780153646	79 Count	253 Count	60 Count
1780152745	72 Count	237 Count	54 Count
1780151844	70 Count	226 Count	53 Count
1780150944	69 Count	226 Count	53 Count
1780150043	68 Count	223 Count	53 Count
1780149143	63 Count	209 Count	49 Count
1780148242	61 Count	191 Count	48 Count
1780147341	60 Count	178 Count	48 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)