EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6PAK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PAK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774732112	47 Count	174 Count	39 Count
1774730311	42 Count	157 Count	35 Count
1774728510	37 Count	134 Count	31 Count
1774726709	32 Count	111 Count	27 Count
1774724908	25 Count	86 Count	21 Count
1774723108	20 Count	67 Count	17 Count
1774721307	16 Count	51 Count	14 Count
1774719514	10 Count	32 Count	9 Count
1774717713	5 Count	16 Count	5 Count
1774715912	244 Count	1008 Count	216 Count
1774714112	240 Count	992 Count	213 Count
1774712311	235 Count	972 Count	209 Count
1774710511	231 Count	940 Count	206 Count
1774708710	224 Count	910 Count	200 Count
1774706909	216 Count	885 Count	193 Count
1774705109	194 Count	836 Count	172 Count
1774703308	188 Count	811 Count	167 Count
1774701507	183 Count	791 Count	163 Count
1774699707	180 Count	769 Count	161 Count
1774697910	156 Count	723 Count	138 Count
1774696110	123 Count	654 Count	106 Count
1774694309	85 Count	581 Count	69 Count
1774692509	64 Count	533 Count	49 Count
1774690708	49 Count	492 Count	35 Count
1774688907	46 Count	471 Count	33 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)