EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1772868890	74 Count	660 Count	52 Count
1772867087	71 Count	627 Count	50 Count
1772865284	69 Count	603 Count	49 Count
1772863517	64 Count	573 Count	45 Count
1772861714	62 Count	531 Count	44 Count
1772859911	60 Count	502 Count	43 Count
1772858108	55 Count	464 Count	39 Count
1772856305	50 Count	420 Count	35 Count
1772854502	47 Count	378 Count	33 Count
1772852698	45 Count	353 Count	32 Count
1772850895	44 Count	331 Count	32 Count
1772849091	37 Count	301 Count	26 Count
1772847288	36 Count	280 Count	26 Count
1772845485	31 Count	254 Count	22 Count
1772843682	29 Count	235 Count	21 Count
1772841913	27 Count	208 Count	20 Count
1772840110	24 Count	184 Count	18 Count
1772838307	23 Count	165 Count	18 Count
1772836504	19 Count	146 Count	15 Count
1772834701	16 Count	119 Count	13 Count
1772832898	13 Count	93 Count	11 Count
1772831095	8 Count	63 Count	7 Count
1772829292	5 Count	37 Count	5 Count
1772827489	284 Count	1002 Count	250 Count
1772825685	281 Count	968 Count	248 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)