EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1772565941	50 Count	624 Count
1772562334	48 Count	560 Count
1772560530	47 Count	537 Count
1772556965	41 Count	448 Count
1772555162	40 Count	424 Count
1772553358	39 Count	402 Count
1772551554	38 Count	389 Count
1772547946	36 Count	355 Count
1772546142	35 Count	338 Count
1772544338	34 Count	322 Count
1772542534	33 Count	306 Count
1772540731	32 Count	287 Count
1772538927	31 Count	255 Count
1772537166	26 Count	237 Count
1772535362	25 Count	221 Count
1772533558	24 Count	205 Count
1772531755	23 Count	179 Count
1772529951	22 Count	148 Count
1772528147	21 Count	129 Count
1772526343	20 Count	117 Count
1772524539	19 Count	100 Count
1772522735	18 Count	77 Count
1772520931	17 Count	45 Count
1772519128	16 Count	21 Count
1772517324	14 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)