EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789236836	170 Count	482 Count	137 Count
1789235932	166 Count	474 Count	134 Count
1789235029	163 Count	465 Count	132 Count
1789234125	159 Count	454 Count	129 Count
1789233222	156 Count	444 Count	127 Count
1789232318	153 Count	435 Count	125 Count
1789231415	150 Count	424 Count	123 Count
1789230512	144 Count	412 Count	118 Count
1789229608	140 Count	394 Count	115 Count
1789228705	137 Count	386 Count	113 Count
1789227884	133 Count	375 Count	110 Count
1789226981	130 Count	365 Count	108 Count
1789226080	126 Count	357 Count	105 Count
1789225174	122 Count	349 Count	102 Count
1789224270	118 Count	342 Count	99 Count
1789223367	114 Count	334 Count	96 Count
1789222464	110 Count	323 Count	93 Count
1789221560	105 Count	299 Count	89 Count
1789220657	101 Count	288 Count	86 Count
1789219754	97 Count	279 Count	83 Count
1789218850	90 Count	267 Count	77 Count
1789217947	80 Count	252 Count	68 Count
1789217043	70 Count	235 Count	59 Count
1789216140	55 Count	206 Count	45 Count
1789215237	53 Count	176 Count	44 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)