EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790964843	103 Count	275 Count	75 Count
1790963939	102 Count	272 Count	75 Count
1790963036	101 Count	268 Count	75 Count
1790962133	100 Count	262 Count	75 Count
1790961229	97 Count	255 Count	73 Count
1790960329	94 Count	249 Count	71 Count
1790959422	90 Count	242 Count	68 Count
1790958519	82 Count	230 Count	61 Count
1790957616	81 Count	225 Count	61 Count
1790956712	80 Count	219 Count	61 Count
1790955891	79 Count	213 Count	61 Count
1790954987	78 Count	198 Count	61 Count
1790954084	77 Count	183 Count	61 Count
1790953181	72 Count	174 Count	57 Count
1790952277	43 Count	142 Count	29 Count
1790951374	42 Count	135 Count	29 Count
1790950471	41 Count	130 Count	29 Count
1790949567	40 Count	126 Count	29 Count
1790948664	38 Count	120 Count	28 Count
1790947761	37 Count	115 Count	28 Count
1790946857	35 Count	113 Count	27 Count
1790945954	34 Count	109 Count	27 Count
1790945050	32 Count	105 Count	26 Count
1790944147	31 Count	100 Count	26 Count
1790943243	29 Count	95 Count	25 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)