EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3KON-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773888466	266 Count	657 Count	80 Count
1773887565	264 Count	649 Count	79 Count
1773886664	260 Count	640 Count	76 Count
1773885763	257 Count	629 Count	74 Count
1773884862	255 Count	621 Count	73 Count
1773883960	251 Count	610 Count	71 Count
1773883060	249 Count	601 Count	70 Count
1773882159	245 Count	589 Count	67 Count
1773881258	243 Count	579 Count	66 Count
1773880357	239 Count	566 Count	63 Count
1773879456	235 Count	555 Count	61 Count
1773878555	231 Count	542 Count	58 Count
1773877654	229 Count	533 Count	57 Count
1773876753	225 Count	520 Count	54 Count
1773875852	222 Count	510 Count	52 Count
1773874951	219 Count	499 Count	50 Count
1773874051	214 Count	486 Count	48 Count
1773873149	212 Count	477 Count	47 Count
1773872249	208 Count	464 Count	44 Count
1773871348	205 Count	455 Count	42 Count
1773870447	202 Count	444 Count	41 Count
1773869546	195 Count	426 Count	40 Count
1773868645	188 Count	411 Count	37 Count
1773867744	178 Count	387 Count	36 Count
1773866866	175 Count	377 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)