EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR3Q Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR3Q. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1773730664	309 Count	593 Count	229 Count
1773730063	303 Count	580 Count	224 Count
1773729463	298 Count	566 Count	220 Count
1773728862	294 Count	551 Count	217 Count
1773728262	288 Count	531 Count	212 Count
1773727658	284 Count	517 Count	209 Count
1773727058	279 Count	494 Count	205 Count
1773726457	273 Count	480 Count	200 Count
1773725856	269 Count	467 Count	197 Count
1773725256	262 Count	453 Count	191 Count
1773724655	242 Count	422 Count	172 Count
1773724055	234 Count	403 Count	165 Count
1773723454	228 Count	396 Count	160 Count
1773722853	221 Count	386 Count	154 Count
1773722253	217 Count	379 Count	151 Count
1773721671	212 Count	372 Count	147 Count
1773721069	206 Count	364 Count	142 Count
1773720469	202 Count	356 Count	139 Count
1773719868	197 Count	349 Count	135 Count
1773719267	192 Count	341 Count	131 Count
1773718667	187 Count	332 Count	127 Count
1773718066	182 Count	326 Count	123 Count
1773717466	176 Count	318 Count	118 Count
1773716865	172 Count	310 Count	115 Count
1773716264	167 Count	304 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)